Filter
Top Products
32 S1000 Autopilot Installation Guide
General Information
Safety notices
WARNING: Product installation & operation
This equipment must be installed and operated in accordance with the Raymarine
instructions provided. Failure to do so could result in personal injury, damage to
your boat and/or poor product performance.
WARNING: Electrical safety
Make sure you have switched off the power supply before you start installing this
product.
Information
To the best of our knowledge, the information in this guide was correct when it went to press. However, Raymarine
cannot accept liability for any inaccuracies or omissions it may contain.
In addition, our policy of continuous product improvement may change specifications without notice. Therefore,
Raymarine cannot accept liability for any differences between the product and this guide.
EMC Installation Guidelines
All Raymarine equipment and accessories are designed to the best industry standards for use in the recreational
marine environment.
Their design and manufacture conforms to the appropriate Electromagnetic Compatibility (EMC) standards, but
correct installation is required to ensure that performance is not compromised. Although every effort has been taken
to ensure that they will perform under all conditions, it is important to understand what factors could affect the
operation of the product.
The guidelines given here describe the conditions for optimum EMC performance, but it is recognized that it may not
be possible to meet all of these conditions in all situations. To ensure the best possible conditions for EMC
performance within the constraints imposed by any location, always ensure the maximum separation possible
between different items of electrical equipment.
For optimum EMC performance, it is recommended that wherever possible:
• Raymarine equipment and cables connected to it are:
• At least 3 ft (1 m) from any equipment transmitting or cables carrying radio signals e.g. VHF radios, cables
and antennas. In the case of SSB radios, the distance should be increased to 7 ft (2 m).
• More than 7 ft (2 m) from the path of a radar beam. A radar beam can normally be assumed to spread 20
degrees above and below the radiating element.
• The equipment is supplied from a separate battery from that used for engine start. Voltage drops below 10 V in
the power supply to our products, and starter motor transients, can cause the equipment to reset. This will not
damage the equipment, but may cause the loss of some information and may change the operating mode.
• Raymarine specified cables are used. Cutting and rejoining these cables can compromise EMC performance and
must be avoided unless doing so is detailed in the installation manual.
• If a suppression ferrite is attached to a cable, this ferrite should not be removed. If the ferrite needs to be
removed during installation it must be reassembled in the same position.
87040_5.book Page 32 Monday, April 30, 2007 5:58 PM