RuggedCom RS900W Marine Radio User Manual


  Open as PDF
of 7
 
7
© 2007 RuggedCom Inc. All rights reserved Rev100
h- Set SSID: Ensure that WLAN Interface -> Network Parameters ->
Network Name [SSID] -> RUGGEDTEST is configured.
i- Set Authentication Mode: Ensure that WLAN Interface -> Security
Parameters -> Authentication Mode -> wpa2-psk is selected.
j- Set Encryption Algorithm: Ensure that WLAN Interface -> Security
Parameters -> Encryption Algorithm -> aes is selected.
k- Set Passphrase [WPA,WPA2]: Ensure that WLAN Interface -> Security
Parameters -> Passphrase [WPA,WPA2] -> testing1234 is configured.
l- Soft reset the wireless interface: Ensure that WLAN Interface ->
Miscellaneous Parameters -> WLAN Reset -> Quick reset is selected.
m- After a ‘Quick reset’ has been executed, the RS900W unit will be
configured for Client/Bridge operation with WPA2 (802.11i) security
enabled. After this step, the Client/Bridge unit will associate with the
similarly configured AP and a ‘ping’ test should work at this point
2.3 Configure the RS900W for “Client / IP Bridge” operation
The only difference between the configuration of “Client / IP Bridge” and “Client /
Bridge” is the selection of “Operational Mode” in Section 2.2 Step (e). Instead of
setting “Client Bridge” option you will set “Client IP Bridge” option in the
“Operational Mode”.
 previous