Filter
Top Products
Page 14 FF520
2.4.4 CPV550
VIDEO 1GPSAUX
1 RAM 2
I/O
VIDEO 2
Black
Red
Fuse
Switch
+
BATTERY
-
Green
Gray
Blue
Brown
White
Yellow
NMEA Common
Port1 Input
Port1 Output
Port2 Input
Port2 Output
Port3 Output
Note:
Gray and White wires should not be connected
to other devices when the FF520 is connected.
FF520 Fish Finder
Accessory cable
Black (no connection)
Red (no connection)
2.5 SOFTWARE SETUP
After connections have been made, the GPS Chart Plotter must be setup to communicate
with the FF520. Port 2 of the NMEA In/Out Communication Setup menu must be changed
to FF520 as shown below for communications.
1. From the Chart page, press [MENU]. Move the ShuttlePoint knob to highlight
SETUP
MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight
ADVANCED SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight
IN/OUT CONNECTIONS and press [ENT] or
move the ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to highlight
PORT 2 INPUT and press [ENT] or move the
ShuttlePoint knob to the right.
5. Move the ShuttlePoint knob up/down to select
FF520 and press [ENT] or move the
ShuttlePoint knob to the right.
6. Press [CLR] or move the ShuttlePoint knob to the left until the Chart page is shown.
2.6 OPTIONAL CONNECTIONS
The FF520 is supplied with connections that allow the FF520 to be connected to the
following external devices: