Filter
Top Products
GX3500SPage 20
[
PWR
]
Key
Turns the transceiver on and off. To turn the transceiver on, press and
hold this key until the LCD turns on. To turn it off, press and hold this key
until the LCD turns off. When the power is turned on, the transceiver is
set to the last selected channel.
CHANNEL SELECTOR KNOB
Rotary knob used to select channels and to choose menu items (such as the
DSC menu, radio setup menu, and DSC setup menu). The
[
UP
(
)]
/
[
DOWN
(
)]
keys on the microphone can also be used to select channels and
menu items.
When the PA/FOG mode is activated, the CHANNEL selector knob adjust
the audio output level.
Secondary Use (Depends on the transceiver version)
While holding down the [SCAN] key and turning the CHANNEL selector
knob, you can confirm memory channels for scanning.
KEYPAD
[
1
(
DIM
)]
Key
When in radio mode, this key is used to directly select channel digit “1” in
a channel number.
Secondary use
Press the
[
F
]
key first then press the
[
1
(
DIM
)]
key, access the LCD Dim-
mer menu. Refer to section “10.15 LCD DIMMER” for details.
[
2
(
MEM
)]
Key
When in radio mode, this key is used to directly select channel digit “2” in
a channel number.
Secondary use (Depends on the transceiver version)
Press the
[
F
]
key first then press the
[
2
(
MEM
)]
key, memorize the se-
lected channel into the transceiver scan memory for scanning. When
repeat the same procedures
([
F
]
[
2
(
MEM
)])
, DELETES the channel
from the scan memory. Refer to section “10.12 SCANNING” for details.
[
3
(
SCAN
)]
Key
When in radio mode, this key is used to directly select channel digit “3” in
a channel number.
Secondary use (Depends on the transceiver version)
Press the
[
F
]
key first then press the
[
3
(
SCAN
)]
key, start and stop the
scanning of programmed channels. Refer to section “10.12 SCANNING”
for details.