Filter
Top Products
7-10
SERIES3800/S120T (7045A-C3/7045A-CT) User's Manual
graphic effects when using a Linux graphic driver that requires the write-combining
confi guration with 4GB or more memory. The options are Enabled and Disabled.
XPCI Confi guration
Access the submenu to make changes to the following settings for PCI devices.
Onboard GLAN1/Onboard GLAN2 (Gigabit- LAN) OPROM Confi gure
Select Enabled to allow the system to boot from the GLAN1 connection or the GLAN
2 connection. The options are Disabled and Enabled.
Reset Confi guration Data
If set to Yes, this setting clears the Extended System Confi guration Data (ESCD)
area. The options are Yes and No.
XSlot1 PCI-X 133/100 MHz, Slot2 PCI-X 133/100 MHz, Slot3
PCI 33 MHz, Slot 4 PCI-Exp. x8/x4, Slot 5 PCI 33 MHz and
Slot 6 PCI Exp. x16
Access the submenu for each of the settings above to make changes to the fol-
lowing:
Option ROM Scan
When enabled, this setting will initialize the device expansion ROM. The options
are Enabled and Disabled.
Enable Master
This setting allows you to enable the selected device as the PCI bus master. The
options are Enabled and Disabled.
Latency Timer
This setting allows you to set the clock rate for Bus Master. A high-priority, high-
throughout device may benefi t from a greater clock rate. The options are Default,
0020h, 0040h, 0060h, 0080h, 00A0h, 00C0h and 00E0h. For Unix, Novell and other
Operating Systems, please select "Other". If a drive fails after installing new soft-
ware, you might want to change this setting and try again. A different OS requires
a different Bus Master clock rate.
Large Disk Access Mode
This setting determines how large hard drives are to be accessed. The options are
DOS or Other (for Unix, Novelle NetWare and other operating systems).