Filter
Top Products
The auto setpoint switching is off by default for the low setpoint
and on for the high setpoint.
To modify setpoint switching:
1. While in CCR mode, keep [DOWN] pressed.
2.
Press [UP] to scroll to SWITCH HIGH and press [SELECT].
3. Press [DOWN] or [UP] to to toggle On/Off and press [SELECT].
4.
Press [DOWN] or [UP] to set value for for SWITCH HIGH in meters
(m).
5. Press [SELECT] to save
6.
Repeat steps 2-4 for SWITCH LOW if necessary.
7. Press [MODE] to exit.
Modify setpoints during a dive
The high and low setpoints or a custom (manual) set point can be
adjusted during a dive.
To modify setpoints during a dive:
1.
While in
CCR
mode, keep [UP] pressed.
2. Scroll to the setpoint you want to adjust with [UP] or [DOWN].
3. Press [SELECT] to enter the setting.
4. Press [DOWN] or [UP] to adjust value.
5. Press [SELECT] to save.
6. Press [MODE] to exit.
3.11.3.4 Changing gases
In CCR dive mode, Suunto DX allows both setpoint and gas changes
to enabled gas mixes during the dive.
To adjust the diluent during a dive:
46