Filter
Top Products
3.25.3 Transmitted data
After pairing, your Suunto DX receives tank pressure data from the
transmitter.
Any time the Suunto DX receives a signal, one of the following
symbols is shown in the lower left corner of the display.
Display Indication
Cd:--
No code stored, the dive computer is ready
for pairing with the transmitter.
Cd:10
Current code number. Code number can be
from 01 to 40.
- - -
The flash symbol is blinking. Pressure
reading exceeds allowed limit (over 360 bar
(5220 psi)).
no conn Text no conn is displayed when the unit
receives no data from the transmitter.
The pressure reading has not been updated
for over a minute. The last received
pressure blinks on and off. The flash
symbol is not displayed.
This state may be caused by the :
1. Transmitter being out of range (>1.2 m
(4 ft))
2. Transmitter is in power saving mode
70