Filter
Top Products
USER GUIDE
Connect the Portable Device
1. Connect the adapter tip into the power jack on the portable device.
2. Slide the ON/OFF switch to ON to turn on myPower ALL Plus.
3. Turn on the portable device and use it as you would normally.
While connected, myPower ALL Plus
will power and charge your device. (As mentioned earlier, myPower ALL Plus will not charge a device
if the voltage setting is lower than that required.)
or
Leave the portable device turned off and myPower ALL Plus will charge the device battery.
4. When finished, slide the ON/OFF switch to OFF.
NOTE: If your portable device displays a low voltage/low capacity or double-beep warning while
myPower ALL Plus is connected, adjust the voltage setting to one level higher
.
TIP: For most portable devices, myPower ALL Plus can be used to power the device even when the
device battery is not installed.
View myPower ALL Plus Battery Capacity
The capacity in myPower ALL Plus will decrease as the battery
powers and/or charges your devices. The remaining capacity is
displayed on the capacity indicator, which is accessed as
described below. As the remaining capacity decreases, the
lights will turn off in sequence from right to left. When the
myPower ALL Plus battery capacity is low, only one green LED
will be on. You should recharge myPower ALL Plus at this time.
When myPower ALL Plus is completely out of battery, all lights
will be off. At this point, you must charge myPower ALL Plus.
1. Press the Capacity Level button to view the capacity as
shown in the Capacity Indicator table.
9
INDICATOR PERCENTAGE
1st 1-10%
2nd 10-25%
3rd 25-40%
4th 40-55%
5th 55-70%
6th 70-85%
7th 85-100%
CAPACITY INDICATOR