Filter
Top Products
14” DISPLAY MASK REMOVAL
1. Remove two rubber seals at the top corners of the
display assembly and two mask seals at the bottom
corners of the display assembly.
2. Remove four M2.5x5 silver screws securing the display
mask.
3. There are 21 latches securing the display mask.
Carefully insert your fingers between the display mask
and the LCD module and pry open the latches starting
from the bottom six latches, to the five latches on the
right and left sides, ending with the top six latches.
FL INVERTER AND 14” LCD REMOVAL
FIELD REPLACEABLE UNIT DOCUMENTATION
Satellite
TM
TOSHIBA
Tough Enough for Today’s World
3000 Series
Latch
Mask seals
Display
mask
LCD
LCD module
FL inverter board
FL cable
LCD/
FL cable
M2x4 brass screws
Tape
M2x3 silver
screws
LCD/FL cable
1. Peel off the tape securing the FL cable.
2. Remove two M2.5x5 silver screw securing
FL inverter board.
3. Carefully lift up the FL inverter board and disconnect
the LCD/FL cable from CN1 and the FL cable
from CN2.
4. Remove two 2.5x6 black screws securing the LCD
top cover.
NOTE: When you open and close the display assembly
with the top cover off, hold it by the hinges to
prevent the brackets from bending.
5. Lay the top cover as shown above.
6. Peel off two capton tapes securing the LCD/FL cable
and disconnect the cable.
7. Remove four M2x3 silver screws securing the LCD
module to the LCD brackets and lift out the module.