Filter
Top Products
CONTROL BOARD REMOVAL
1. Remove four M2.5x3 black screws securing the
control switch board.
2. Disconnect the control switch/LED board from JP4
on the main PCB.
KEYBOARD REMOVAL
4. Lift out the keyboard and set it as shown above.
5 Disconnect the keyboard cable from JP5 and IPS switch
cable from JP4 on the video board and lift out the
keyboard.
FIELD REPLACEABLE UNIT DOCUMENTATION
Satellite
TM
TOSHIBA
Tough Enough for Today’s World
3000 Series
KEYBOARD REMOVAL
1. Open the display panel.
2. Using the case separator, unlatch the keyboard holder
at the top of the keyboard.
3. Disconnect the control switch/LED board cable
from the keyboard holder.
4. Remove four M2.5x3 silver screws securing the
keyboard clip.
Keyboard
holder
Keyboard holder
Display
panel
Case separator
JP1
Control board cable
M2.5x3 silver screws
Keyboard
Keyboard cable
JP5
JP4
IPS switch
cable
M2.5x3 black screws
Control
switch
board
Note: When reinstalling the keyboard holder, make sure
that the wireless switch is latch properly to the control
switch board switch.
Wireless switch
Board
switch