Filter
Top Products
Important Notes
1. During shipping or in the course of normal play, it is possible for scoring segments of this
board to become temporarily jammed, resulting in a “frozen” board. If this occurs, the built-in
Self Diagnostic Function of the e-BOARD Computer will be activated automatically. Your
dartboard will run a self-test routine to determine which segment is stuck. An error message
will flash on the display together with the number for the “frozen” segment. Take the following
steps immediately when the error message appears.
a) Find the “frozen” segment according to the display.
b) Press firmly down on the “frozen” segment until it breaks free and the loose fit is restored.
Once the “frozen” segments are loosened the error message should be gone and the
board will continue to operate normally.
2. Never use metal tipped darts on this dartboard! Metal tipped darts will seriously damage
the circuitry, the e-BOARD Computer and electronic operation of the dartboard.
3. Do not use excessive force when throwing darts. Throwing a dart too hard will cause
frequent tip breakage and cause excessive wear on the board.
4. Use only the provided AC adapter. Using the wrong adapter may cause electrical shock
and damage to the unit!
5. Do not spill liquids on the dartboard. Do not spray cleaners that contain ammonia or other
harsh chemicals, as they may damage the dartboard. Instead, we suggest regular dusting
with a damp cloth. Use a mild detergent and a damp cloth for more vigorous cleaning.
Mounting (Physical Installation)
The dartboard should be hung on a wall stud, with the center of the bull’s-eye 68" above the
floor. Regulation throwing distance for soft-tip darts is 8 feet, so be sure there are about 10'
of open floor space in front of the board.
Place two marks side-by-side on the selected wall stud 75
5
/
8
" (192cm) above the floor, with
16" (40 cm) between them. Screw two screws into the reference marks until the screw heads
are protruding about
1
/
2
" from the wall.
Line up the slotted mounting holes on the back of the game with the screw heads then mount
the game. It may be necessary to adjust the screws until the board fits snugly against the wall.
After the board is mounted, the bull
’
s-eye should be 68" (172.72 cm) above the floor.
Please see page 3.
Power Installation
The dartboard is designed to be powered by an AC to 9V DC, 800 milliamp (minimum)
adapter, with the DC plug polarity configur
ed as positive (+) outside, and negative (-) center
.
To connect by adapter, plug the DC plug into the DC
power jack and the AC plug into an
electrical outlet.
2