Xantrex Technology XS400 Marine Battery User Manual


 
Preparing for Installation
975-0054-01-01 2–3
Preparing for Installation
Read this entire installation chapter so you can plan the installation from
beginning to end. Prior to beginning your installation, review the
“Important Safety Instructions” on page vii.
Installation Codes
It is the installer’s responsibility to determine which codes apply and to
ensure that all applicable installation requirements are met.
Applicable installation codes vary depending on the specific location and
application of the installation. Some examples are:
The U.S. National Electrical Code (NEC)
The Canadian Electrical Code (CEC)
Canadian Standards Association (CSA), and RV Industry Association
(RVIA) requirements for installation in RVs.
WARNING: Electrical shock and fire hazards
Xantrex recommends all wiring be done by qualified personnel.
Disconnect all AC and DC power sources to prevent accidental
shock. Disable and secure all AC and DC disconnect devices
and automatic generator starting devices.
It is the installer’s responsibility to ensure compliance with all
applicable installation codes and regulations.
WARNING: Fire hazard
To meet regulatory requirements, the XS400 must be mounted
on a flat horizontal surface with the front panel in the upright
position.
WARNING: Restrictions on Use
The XS400 Sine Wave Inverter shall not be used in
connection with life support systems or other medical
equipment or devices.