Filter
Top Products
Maintenance and care
91
(3) Make sure that the handlebars are facing
straight ahead, and then adjust the free
play by turning the adjuster.
(4) Hold the adjuster with one wrench while
tightening the locknut with another
wrench. Slide the rubber cover to its orig-
inal position.
(5) Install the front handlebar cover, and then
install the eight screws.
FX Cruiser SHO
(1) Remove the ten screws, and then re-
move the front and rear handlebar cov-
ers.
(2) Slide the rubber cover away from the ad-
juster, and then loosen the locknut.
(3) Make sure that the handlebars are facing
straight ahead, and then adjust the free
play by turning the adjuster.
(4) Hold the adjuster with one wrench while
tightening the locknut with another
wrench. Slide the rubber cover to its orig-
inal position.
1 Rubber cover
2 Locknut
3 Adjuster
4 Throttle lever free play
Throttle lever free play:
2.0–5.0 mm (0.08–0.20 in)
1 Front handlebar cover
2 Rear handlebar cover
1 Rubber cover
2 Locknut
3 Adjuster
4 Throttle lever free play
Throttle lever free play:
2.0–5.0 mm (0.08–0.20 in)
UF1W11E0.book Page 91 Tuesday, May 27, 2008 8:50 AM