Filter
Top Products
Features and functions
32
● Lock mode of the Yamaha Security System
has been selected. (See page 36 for
Yamaha Security System lock and unlock
mode selection procedures.)
● Clip is removed from the engine shut-off
switch.
● Throttle lever is squeezed.
EJU31210
Throttle lever
Squeeze the throttle lever to increase engine
speed.
Release the throttle lever to decrease engine
speed or to return it to the idle position.
EJU36740
Cooling water pilot outlets
This watercraft is equipped with cooling water
pilot outlets on the port (left) and starboard
(right) sides of the watercraft.
When the engine is running, cooling water is
circulated in the engine, and then it is dis-
charged from the pilot outlets.
To check for proper operation of the cooling
system, check that water is being discharged
from the port (left) pilot outlets. If water is not
being discharged from these outlets, cooling
water may not be circulating in the engine.
When this occurs, stop the engine and check
for the cause. (See pages 41 and 88 for more
information.)
TIP:
● If the cooling water passages are dry, it will
take about 60 seconds for the water to
reach the outlets after the engine is started.
● Water discharge may not be constant at
idle, therefore, open the throttle a little to
check that water discharges properly.
EJU31260
Steering system
Your watercraft can be steered by turning the
handlebars in the direction you wish to travel.
When the handlebars are turned, the angle of
the jet thrust nozzle is changed, and the direc-
tion of the watercraft is changed accordingly.
1 Throttle lever
1
1 Handlebar
2 Jet thrust nozzle
1
2
UF2R10E0.book Page 32 Friday, October 31, 2008 9:14 AM