Filter
Top Products
Features and functions
37
TIP:
● The beeper sounds two times for the nor-
mal operation mode or three times for the L-
MODE (low-RPM mode). (See page 37 for
L-MODE selection procedures.)
● If the remote control transmitter is operated
while the dual analog meter unit is in the
standby state, the unit will perform the initial
operation, and then the setting is selected.
To select the lock mode:
Press the lock button on the remote control
transmitter briefly. The beeper sounds once
and the “UNLOCK” indicator light blinks once,
then goes off. This indicates the lock mode is
selected.
To select the unlock mode:
Press the “L-Mode” (unlock) button on the re-
mote control transmitter briefly. The beeper
sounds two or three times and the “UNLOCK”
indicator light blinks two or three times, then
comes on. This indicates the unlock mode is
selected.
EJU37420
L-MODE (low-RPM mode)
The L-MODE limits the engine speed to ap-
proximately 70% of the maximum engine
speed.
The L-MODE activation and deactivation can
only be selected using the remote control
transmitter. (See page 29 for information on
using the remote control transmitter.)
TIP:
The L-MODE can only be selected when the
engine is stopped in the unlock mode of the
Yamaha Security System.
Activating and deactivating the L-MODE
Activation of the L-MODE will be confirmed by
the number of beeps when the remote control
transmitter is operated, and by the “L-MODE”
Number of
beeps
Yamaha Security
System mode
“UN-
LOCK” in-
dicator
light
Lock Goes off
Unlock
(normal operation
mode)
Comes
on
Unlock
(L-MODE)
Comes
on
1 Lock button
2 “UNLOCK” indicator light
2
1
1 “L-Mode” (unlock) button
2 “UNLOCK” indicator light
1 Remote control transmitter
2
1
UF2R10E0.book Page 37 Friday, October 31, 2008 9:14 AM