A SERVICE OF

logo

20
4 - Operations
4 OPERATIONS
4.1.A KEYS FUNCTIONS AND DISPLAY IN OPERATOR MODE
274.8
275.0
1
2
3
MAN
Setpoint
setting
OP1 output ON
OP2 output ON
OP3 output ON
Menu
access
Enter key for
selection and
value setting
confirmation
PV control input
in engineering
units
Operating
Setpoint
(At the power
on the target
Setpoint value
is displayed for
3 seconds)
Output status
LEDs
(red):
When the measured
value is greater than
sensor high range
When the measured
value is less than the
sensor low range
RUN
Start-up/Timer
running (green)
Fuzzy Tuning running
(green):
blinking
Manual
operating mode
(green): steady
SP2
Stand-by
Setpoint enabled
(green): steady
Values
modification
Enter key for
selection and
value setting
confirmation
Access to the
menu for:
- configuration
- parameter setting
Parameter value
Parameter mnemonic
35.0
p.b.
1
2
3
A / M
4.1.B KEYS FUNCTIONS AND DISPLAY IN PROGRAMMING MODE