A SERVICE OF

logo

Open as PDF
next previous
pass
33
OK
37
4 - Operations
Code entry [2]
from 0 to 4999 (
33 default from factory)
The entered password must correspond to
the one store in the
Code parameter.
Password entry [2]
only if
Code value <5000
A
Direct access to the configuration
A From parameterisation (see page 28).
B At the first power on when the
controller is not configured:
In this situation, the controller has its outputs and inputs not active.
This situation ends when a correct configuration code is entered.
Conf
9999
Table 1 - Supported Engineering Units.
Notes
[1] Minimum Range 100 digits.
[2] If password is 0000 to 4999, parameter
setting will be available to the operator
without entering this password number. If
password is 5000 to 9999, parameter set-
ting will only be available by entering this
password number.
mV
nU
Volt
U
mA
MA
Centigrade degrees*
°C
Ampere
Fahrenheit degrees *
°f
A
Bar
bAr
PSI
nessuna
none
psI
Rh
rh
pH
ph
* For inputs from thermocouple or resis-
tance thermometer, the choice is between
°C and °F only.
Stand-by Setpoint
s.p. 2
Timer launch
str.t
Not used
Off
Keypad lock
keb.I
Auto/Man
A.Man
Table 2- Digital input functions
NOYES