8
Step 4
Position downrod so the hole in the downrod aligns with the hole in the
Flange Coupling on the motor. Insert safety bolt (S6) through coupling
and downrod and attach nut. Tighten firmly. Tighten set screw "A"
against downrod. Place Flange Cover (#10) and Canopy Decorative
Cover (#11) and Canopy over Downrod Assembly. Replace hanging ball,
insert hanging pin through downrod and tighten set screw "C" in
hanging ball into downrod.
Connect the hot(black) and neutral(white) wires from the Fixture Plate
(6) to the corresponding wires from the Fan Housing & Motor (5) and
attach Fixture Plate using the three mounting screws supplied. Install
included CFL Bulb (7) into socket and cover with twist-lock Glass (8).
Step 3 - Standard Down Rod Assembly (Steps 3-7)
Locate downrod assembly (#2). Loosen ball screw on black hanging
ball to free lock pin. Black hanging ball will slide down. Remove
ground screw and green ground wire. Remove hanging ball from
downrod and save all parts. Insert fan wires through downrod. Screw
Downrod into top of Fan Motor Housing, being careful that wires are
pulled through.
7
WARNING:
Failure to completely tighten downrod could result in the fan loosening and
possibly falling.
IMPORTANT:
Black antenna wire must be connected for remote to function.
Safety Cable (Canada)
Set Screw (C)
Downrod (2)
Canopy (3)
Flange Cover (10)
Top Motor Housing (4)
Motor Housing (5)
Safety Bolt & Nut (S7)
Set Screw (A)
Hanging
Pin
Hanging
Ball
Ball Screw
Ground
Wire
readed Set
Screw Hole
Fixture Plate (6)
CFL (7)
Glass (8)
