Electrical Connections
Connect black fan wires to black outlet wire. Connect white fan wire
to white outlet wire and green grounding lead wire from the
grounding conductor to the supply circuit (see figure A). Use wire
connectors provided with your fan. No loose strands or loose
connections should be present. Turn splices upward and carefully push
all wiring into outlet box. When wall switches are employed, switches
should be UL listed for use with ceiling fan.
14
Operation Instructions
ON/OFF For emergency shut off.
HIGH Controls fan motor speed. To select desired speed,
MEDIUM press button once and release
LOW
REVERSE Controls direction of fan blades. To reverse fan blades,
press once and release.
FAN OFF Turns fan motor speed off. Press once to turn off. To
start motor speed again, hit one of the motor speed
buttons.
L-1 Controls no function on this fan.
L-2 Controls the on/off and intensity for integrated light kit.
Push and release for on/off function. Hold down for full
range light dimming.
NOTE: The "High", "Medium" or "Low" buttons may be used to
start the fan motor. The speed of the fan may be changed
at any time.
Common Problems
Problem A: Fan Will not Start
Remedies: 1. Check fuse or circuit breaker and replace if necessary
2. Turn off electrical power and check all wire connectors.
3. Check on/off TCS and wall control selector switch. See operation
instructions.
Problem B: Fan is Excessively Noisy
Remedies: 1. Check that all screws in fan assembly are tight and properly seated.
2. Check to make sure mounting bracket is installed properly.
3. Check to make sure light kit and glass reinstalled properly and tight.
4. If wall control is used, insure the wall control is not a transformer or a
variable speed type.
Problem C: Fan Wobbles
Remedies: 1. Check that all blades are screwed firmly into blade holders.
2. Check that all blade holders are screwed firmly into motor.
3. Check the weight of blades. All our blades are weighed on electronic
scales. The weight is marked on the reverse side of the fan blade near the
motor end. All of the blades should be the same weight to prevent fan
from wobbling.
4. A balancing kit is enclosed if needed.
Weight: The weight of the complete fan, including assembly hardware is 36 lbs.
CAUTION:
Always turn off power at
breaker before attempting
any wire connections.
Ground
White
Black
Black
Green
White
Fan and lights
controlled by remote
control unit
