1)
2) From
From the FIBER LINK MENU, press to LOAD/EDIT the link.
the STORED LINKS menu, highlight the link name you wish to use.
The currently loaded link is denoted by an asterisk.
NOTE: take care to NOT overwrite a previously configured link
unless it is no longer needed.
3) Press to set the link information.
4) Edit the LINK NAME by pressing . It is recommended to change the
link name to better describe the link. The link name field can support up
to 17-character names. Press when finished.
5) Edit the DATE by pressing . It is of vital importance to change the
date using the format MM-DD-YY. If the date is entered incorrectly,
or not entered at all, Extech Reporter will display an incorrect date on the
software and reports. Press when finished entering the date, then
press again to continue.
6) Press to load the link.
F3F3
F1F1
F2F2
F2F2
3-2
CERTIFICATION METER
UNIT 3
The MAIN MENU activates the advanced functions of the FiberMeter. To open
the MAIN MENU, press and it will appear as shown as the figure at the right.
These functions are activated by pressing the corresponding key, and are
described in more detail below.
NOTE: OPTIONS 5 AND 6 WILL NOT APPEAR IF THE OPTIONAL LIGHT
SOURCE IS NOT INSTALLED.
MAIN MENU
<1>FIBER LINK SETUP - enters the FIBER LINK MENU. This menu allows the
user to configure and manage fiber links in the FiberMeter. The meter can store
up to eight separate fiber link configurations. The parameters contained in each
fiber link apply to all data points stored while that link was loaded.
MAIN MENU - FIBER LINK MENU
<1>LINK
<2>LOAD/EDIT
<6>PRINT
<3>CONFIGURE
<4>VIEW
FIBER
<5>DELETE
MENULINK
LINK
LINK
LINK
LINK
LINK
CONFIG
WIZARD
FIBER LINK MENU
This menu option runs the Link Wizard. See the section “CERTIFICATION METER - Cabling Standard
Certification Test” in this unit for instructions on running the Link Wizard.
MAIN MENU FIBER LINK - MENU - LINK WIZARD
NAME
ACME
DATE
CORP.
02-26-07
_____________________
LINK
Link Information
MAIN MENU FIBER LINK - MENU - LOAD/EDIT LINK
<1>FIBER
<2>TAKE
<6>TEST
<3>STORED
<4>METER
MAIN
<5>SOURCE
MENU
FIBER
READINGS
LINK
PROPERTIES
READINGS
CONTROL
LENGTH
MAIN MENU
SETUP
STORED LINKS
MENU
NEXT
STORED
_____________________
SELECT
LINKS
Fiber Link #1
Fiber Link #2
Fiber Link #3
Fiber Link #4
*
RENAME
MENU
2
DEF
DONE
DONE
DONE
