GPSMAP 3006C/3010C Owner’s Manual 3
gettIng started > usIng the gPsMaP 3006c/3010c KeYPad
GettInG
started
Using the Optional Marine Remote Control
Use the keypad on the optional Marine Remote Control to operate your
GPSMAP 3006C/3010C from a distance. Contact your Garmin dealer or Garmin
Product Support to purchase the Marine Remote Control.
To operate the remote control, point the IR (infrared) window on the
remote toward the unobstructed IR window on the lower-right corner of the
GPSMAP 3006C/3010C.
All keys on the remote control operate in the same manner as the keypad on the
GPSMAP 3006C/3010C. Each key’s primary function appears on the key. To
activate the secondary functions for the ADJ/MENU, NAV/MOB,
DATA/CNFG, and Thumb Stick (ENTER/MARK) keys, press and hold the key.
The Thumb Stick combines the operations of the ROCKER and
ENTER/MARK key. Use it to select menu options, change settings, enter data,
and conrm entry. You can also control movement of the pointer on the Map
Page. Press in on the Thumb Stick to select a highlighted item or begin data entry.
Press and hold the Thumb Stick to mark a waypoint.
Installing the Remote Control Batteries
The remote requires two AAA alkaline batteries. To install the batteries, press
down on the battery door clip, and then pull the battery door away from the
remote. Install the batteries, observing the correct polarity (see the inside of the
battery compartment). Replace the cover, and make sure it is closed all the way.
NOTE: The remote is for use in shaded or enclosed environments. Direct
sunlight interferes with infrared operation. The Marine Remote Control is NOT
waterproof.
15)4
0!'%
.
!$*
-%.5
.!6
-/"
$!4!
#.&'
!"#
$%&
'()
*+,
-./
0123
456
789:
://-
2!.'%
%.4%2
IR window
Thumb Stick
Marine Remote Control
