A SERVICE OF

logo

Open as PDF
next previous
GPSMAP 3006C/3010C Owner’s Manual 65
MaIn Menu > sYsteM tab
MaIn
Menu
NMEA Interface
If you are going to use the GPSMAP 3006C/3010C with a NMEA device (such
as a VHF radio or autopilot), the unit needs to be set to input/output NMEA
data. See the GPSMAP 3006C/3010C & GPS 17 Installation Instructions for
information on wiring and NMEA data.
To activate the NMEA data:
1. HighlightthePort 1orPort 2eld,andpressENTER.
2. HighlightNMEA In/NMEA Out,andpressENTER.
When transferring data between two Garmin units, always set one to Host and
use the other unit to send or request the data.
Advanced NMEA Output Setup
The GPSMAP 3006C/3010C NMEA data transmission can be customized to
change the precision of the Lat/Lon minutes, set up the waypoint IDs, and keep
the output rate at two seconds. If the unit is set up to output all of the available
NMEA sentences, the output rate may exceed two seconds.
Use the Advanced NMEA Setup Page to turn the GPS status (GSA, GSV),
Waypoint/Route (WPL, RTE), and the Garmin proprietary sentences on or off.
Check any other equipment’s owners manual to see what sentences are required
to be enabled for functionality.
Lat/Lon Minutes Precision
allows you to adjust the number of digits to the right
of the decimal point for transmission of NMEA Output, either 2, 3, or 4 digits.
Use the Waypoint ID setting to output the waypoint identiers as names or
numbers.
Advanced NMEA Setup Page
To change the advanced NMEA settings:
1. Pressthe NMEA SetupsoftkeytoopentheAdvancedNMEASetup
Page.
2. Tochange,enable,ordisableNMEAoutputsentences,highlightthe
sentence,andpressENTERtoselectorclearthecheckbox.Only
selectedsentencesareoutput.