Section 2. Create the Drivers Diskettes
1. Locate one blank, formatted 3.5" diskette.
2. Insert your HP Startup CD in a Windows PC and follow the on-screen
instructions to create the HP Server tc2120 NetWare SCSI drivers (HP disk NW
SCSI).
NOTE: If the Windows PC does not auto-start the Startup menu, start it by opening
Startup.htm, found at the root level of the Startup CD.
Section 3. Perform NetWare 6.0 Installation
The installation of NetWare 6.0 or SBS 6.0 contains several phases:
• Phase 1 – Start the Installation
• Phase 2 – Install HP Drivers
• Phase 3 – Configure the Network
• Phase 4 – Install the Support Pack
Phase 1 – Start the Installation
NOTE: If your hard drive contains data or is not new, HP recommends using a utility such as
fsidk to erase all data and partitions from your hard drive.
For NetWare 6.0
1. Insert the Novell NetWare 6.0 CD-ROM and boot the system.
2. Press Enter to read the license agreement then press Esc, and select "Accept
License Agreement.”
3. Press Enter to "Create a New Boot Partition.”
4. Depending on the size of the booting storage device and available memory of the
server, the installation program will recommend an appropriate boot partition
size. HP recommends a 1000-MB boot partition. Choose continue to proceed.
51
HP CONFIDENTIAL
Writer: Jimmy Chan File Name: 312977-006.doc
Codename: Condor II Part Number: 312977-006 Last Saved On: 9/10/03 10:05 AM
