CRANKSHAFT/TRANSMISSION 10-19
Transmission
Shift Lever Installation
•
Twist the tie-rod end [A] and tie-rod end locknut [B] to
bottom of the screw and then turn back to dimension with
77° ± 10° [C] as shown.
•
Tighten the locknut against the tie-rod end:
Torque - Tie-rod End Locknut: 20 N·m (2.0 kgf·m, 14 ft·lb)
•
Apply molybdenum disulfide grease:
Outside of Tie-rod End Collar [D]
•
Apply grease to the oil s eals, and install them.
•
Tighten:
Torque - Tie-rod End Bolt [E]: 9.8 N·m (1.0 kgf·m, 87 in·lb)
•
Align the mark [A] on the shaft end with the slit [B] of the
shift shaft lever.
•
Position the shift shaft lever end [C] on the boss-center
[D] of the crankcase.
•
Install:
Bracket [ E]
Shift Lever Assembly N ut [F]
•
Tighten:
Torque - Shift Lever Assembly Nut: 20 N·m (2.0 kgf·m, 14
ft·lb)
Tie-rod End Nut [G]: 20 N·m (2.0 kgf·m, 14 ft·lb)
