A SERVICE OF

logo

Open as PDF
next previous
12-52 FIN AL DRIVE
Rear Propeller Shaft
Rear Propeller S haft Removal
•
Remove:
Footboard (see Frame chapter)
•
Slide the rubber boots [A].
•
Push the front universal joint [B] rearward, and remove
the front end [C] from the engine.
•
Remove the r ear propeller shaft [A] from the vehicle.
Rear Propeller Shaft Installation
•
Wipe off any old grease:
Splines [A] of Propeller Shaft and Universal Joint
Output Shaft of Engine
Pinion Gear of Rear Final Gear Case
•
Inspect O-rings [B] and boots [C] for damage.
If any doubt exists, replace it with a new one.
•
Apply molybdenum disulfide grease:
Spline [A] and Inside [B] of Propeller Shaft [C]
•
Install:
Boots [D]