SYMPTOM POSSIBLE CAUSE REMEDY
(Continued)
■ If a problem occurs
If this unit functions abnormally during operation, first check the following items. If the unit continues to function abnormally,
or if an abnormality appears other than listed below, turn off the player’s power and disconnect the AC power plug, then
consult your SHARP dealer or service personnel.
General
SYMPTOM POSSIBLE CAUSE REMEDY
The clock is wrong. Did a power failure occur? Try setting it again.
When a button is pressed, the unit
does not respond.
Turn the power off and on again, and
then retry the operation.
Radios make unusual noise or the pic-
ture on the TV screen is distorted.
When a radio or TV which uses an
indoor antenna is placed near the
unit, the picture on the TV screen may
be distorted or the radio may not func-
tion properly.
It is recommended that you use an
outdoor antenna.
Audio
A recording cannot be made. Is the MiniDisc protected against ac-
cidental erasure?
Slide the accidental erase prevention
tab back to its original position.
Did you try to make recording on a
playback-only MiniDisc?
Replace it with a recordable disc.
Can you see the “TOC FULL” mes-
sage in the display?
Put in another recordable disc with
recording space on it.
Even though a disc has been loaded,
“no disc” or “Error” is displayed.
Is the disc scratched?
Is the unit located near excessive
vibrations?
Replace the disc.
Place the unit on a firm, level surface
free from vibration.
Playback stops in the middle of a
track, or playback is not performed
properly.
Is the unit located near excessive
vibrations?
Place the unit on a firm, level surface
free from vibration.
Playback sounds are skipped.
Has condensation formed inside the
unit?
Remove the disc and leave the power
turned on. The unit should function
properly in about 1 hour.
Remote control
SYMPTOM POSSIBLE CAUSE REMEDY
The remote control does not function
or does not operate properly.
The batteries (polarity) are not inserted
properly.
Insert properly.
The batteries inside the remote control
are dead.
Replace the batteries.
The remote control is operated from
an incorrect distance or angle.
Operate it within a range of 8" (0.2 m)
to 20’ (6 m) and within an angle of 15
o
to either side of center.
No disc has been loaded. Load a disc.
The power cannot be turned on from
the remote control.
Is the AC power cord plugged in? Connect the AC power cord.
MD-R2
36
