43
● To Control a Recorder via the Network
The following is the description of the connection between
a recorder and this unit to control the recorder via the net-
work.
1. Set the recorder's unit address to a number 5 or larger .
(Refer to the recorder's operating instructions.)
2. Connect the unit’s CAM OUT 1 to 16 connectors to the
recorder’s VIDEO IN 1 to 16 connectors with a coaxial
cable.
3. Connect the unit’s DATA HDR and DATA4 connectors
to the recorder’s DATA port with a daisy chain connec-
tion cable kit (WV-CA48/10K).
(The control data and alarm signal will be output from
the unit to the recorder.)
4. Select the recorder's new unit address, which is set in
step 1, for DATA HDR in the Data Port window. (Refer to
p. 66.)
5. Through a browser, set the unit address of an optional
network board (WJ-HDB502) to a number other than 1.
(Refer to WJ-HDB502 Operating Instructions.)
6. Refer to p. 39, p. 41 and p. 42 for MONITOR OUT con-
nection, MULTI SCREEN OUT connection, and EXT IN
connection.
43
Notes:
• You will need WJ-HD500A or a newer model, in which
an optional network board (WJ-HDB502) is installed.
• Select the PS·Data protocol for the DATA 4 setting.
(Refer to p. 61 DATA 4/PSD PORT SELECT or p. 81
Data Port.) If the terminal mode is selected, you cannot
control the recorder.
• The recorder will not be operable if its unit address is
set to 1.
• If the recorder's unit address in step 1 and the DATA
HDR setting in step 4 are different, the recorder will not
be operable.
• In these connections, you cannot use a PS·Data system
controller.
