95
■ Patrol Learn and Play
A routine of manual operations can be stored for a specific
time and later reproduced repetitively.
1. Select the desired monitor and camera. (Refer to p. 90
Monitor Selection and p. 91 Camera Selection.)
2. Press the AUTO PAN button three times while holding
down the SHIFT button.
"LEARN" will appear on the LED display of the controller
as shown in the figure.
■ Changing to Black and White Images
This function gets the clear camera images on the monitor
while shooting the objects under low light conditions.
1. Select the desired monitor and camera. (Refer to p. 90
Monitor Selection and p. 91 Camera Selection.)
2. Press the AUTO PAN button two times while holding
down the SHIFT button.
"BLACK (black)" will appear on the LED display of the
controller as shown in the figure.
3. Press the button 1 to change the image from the color
mode to the black and white mode on the active moni-
tor.
"BL ON (BLACK ON)" appears on the LED display to
indicate the selected mode.
4. Press the button 2 to change the black and white image
to the color image on the active monitor.
"BL OF (BLACK OFF)" appears on the LED display to
indicate the selected mode.
5. Press the MON (ESC) button to exit from the mode.
Note: When the black and white parameter is set to
AUTO in the camera's SETUP MENU, this function
is disabled.
3. To save the patrol sequence, follow the procedure
below.
q Press the button 2, then press the CAM (SET) but-
ton.
"LE R" appears on the LED display.
w Operate the camera manually.
e Press the button 3.
The operation data is saved and "LE S" appears on
the LED display.
4. To reproduce the operation data, follow the procedure
below.
q Press the button 1.
"LE P" appears on the LED display.
w Press the button 3.
The reproduction is ended.
5. To exit from the mode, press the MON (ESC) button.
