93
■ Call Preset Position
1. Select the desired monitor and camera. (Refer to p. 90
Monitor Selection and p. 91 Camera Selection.)
2. To select the desired preset position number, press the
numeric buttons.
4. When you have selected a wrong number, press the
CLEAR button to clear the numeric input.
3. Press the CALL PRESET button to move to the preset
position of the selected camera on the active monitor.
■ Program Preset Position
1. Select the desired monitor and camera. (Refer to p. 90
Monitor Selection and p. 91 Camera Selection.)
2. To move the camera to the position to be preset, move
the joystick and press the lens control buttons.
3. To select the desired preset position number, press the
numeric buttons.
4. When you have selected a wrong number, press the
CLEAR button to clear the numeric input.
4. Press the CALL PRESET button while holding down the
SHIFT button to save a preset position of the selected
camera.
Notes:
• If the entered position number has stored the previ-
ous preset position, it will be overwritten by the new
one.
• SETUP MENU and WJ-SX150 Administrator
Console can configure each operator's pan/tilt con-
trol. (Refer to p. 62 OPERATOR REGISTRATION or
p. 75 Operator Registration.)
Note: To use the above function, you must set the pre-
set position number for the camera.
