P314 Broadband Sharing Gateway with 4-Port Switch
Hardware Installation and Setup 2-11
on LAN
to use the MAC Address of that workstation whose IP you
give in the following field.
IP Address
This field is applicable only if you choose
IP Address attached on
LAN
method. Enter the IP address of the workstation on the LAN
whose MAC you are cloning.
2.9 LAN Setup
This section describes how to configure the LAN using
Menu 3 – LAN Setup (10/100 Mbps Ethernet)
.
From the Main Menu, enter 3 to open Menu 3.
Figure 2-10 Menu 3 – LAN Setup
2.9.1 LAN Port Filter Setup
This menu allows you to specify the filter sets that you wish to apply to the LAN traffic. You seldom need to
filter the LAN traffic, however, the filter sets may be useful to block certain packets, reduce traffic and
prevent security breaches.
Figure 2-11 Menu 3.1 – LAN Port Filter Setup
Menu 3.2 is discussed in the next chapter.
Menu 3 - LAN Setup
1. LAN Port Filter Setup
2. TCP/IP and DHCP Setup
Enter Menu Selection Number:
Menu 3.1 – LAN Port Filter Setup
Input Filter Sets:
protocol filters= 2
device filters=
Output Filter Sets:
protocol filters=
device filters=
Press ENTER to Confirm or ESC to Cancel:
