Filter
Top Products
Operating QUESTempº 44/46
Print
12
Print
Allows printing to a parallel or serial printer or to a computer. The QuesTempº 44/46
will recognize the cable plugged in and configure itself for serial or parallel. If no cable
is plugged in, it will default to serial. Press I/O Enter key to begin printing. Press
Run/Stop key to return to the menu.
NOTE:
if you wish to stop the printing, press I/O enter key until you return to the
main menu. When the printer has stopped printing, remove the cable from the printer
to the instrument.
Reset
Resetting enables you to clear the logged data from memory. Press the I/O Enter
key to enter the Reset mode. Clear the memory by holding down the I/O Enter key
while the display counts down from three.
Run
The run mode begins a session in memory and logs the data.
1. Begin a session by pressing the Run/Stop key from the view mode (or
measurement view). An asterisk in the lower right corner indicates the run mode.
To toggle through the views, press the up or down arrow.
Figure 1-8 Run mode indicator
2. End the session by pressing the Run/Stop key again. (The session will stop
recording when the asterisk is no longer displayed.)
NOTE: If the logging memory is full or if there are no sensors plugged into the unit,
attempting to enter the Run mode will result in an error message. If the memory
capacity is exceeded, the asterisk in the lower right corner of the display will turn
into an “F” and the memory remaining screen will show “0.0”.
WBGTi 66.7º F 1
WBGTo 68.6
º
F
Run indicator