Operating QUESTempº 48N
View
Operating QUESTempº 48N
From a powered on mode, the main menu
will appear (after the start-up screens are
displayed.) Use the Up Arrow and Down
Arrow keys to move the marker in the
display in front of the desired mode. Pressing
the I/O Enter key will select the mode.
Figure 1-9: Main menu example
View
Displays the measured data but does not log it. If more than one set of sensors
is plugged into the unit, they can be displayed by pressing and releasing the I/O
Enter key. The displayed sensor set is shown in the upper right corner.
Figure 1-10: Viewing measured data
NOTE: To return to the main menu, hold down the I/O Enter key while a
3, 2, 1 countdown is shown in the lower right corner of the display.
Setup
The setup options are from the main menu when Setup is selected. At any time,
to exit (or escape) a screen, press the Run/Stop key. Table 1-2 identifies the
setup parameters.
Selectable: English, Spanish, French, Italian, and German
Time settings: 24-hour clock
Day-month-year format
1, 2, 5, 10, 15, 30, 60 minutes log rate options
Event Log: when run/stop is pressed, an event or snapshot
of the current conditions is logged into memory. The events
range from 0-99.
ACGIH, PHEL, FLAG, or none (denoted “----”)
Table: 1-2: Settings indentified
View mode
Arrow icon Indicates you are in view mode
Event #
Last logged event/session
