Filter
Top Products
Operating QUESTempº 48N
Print
10
Print
Allows printing to a parallel or serial printer or to a computer. The QUESTempº
48N will recognize the cable plugged in and configure itself for serial or parallel.
If no cable is plugged in, it will default to serial. Press I/O Enter key to begin
printing. Press Run/Stop key to return to the menu.
NOTE:
if you wish to stop the printing, press I/O Enter key until you return
to the main menu. When the printer has stopped printing, remove the cable
from the printer to the instrument.
Reset
Resetting enables you to clear the logged data from memory. Press the I/O
Enter key to enter the Reset mode. Clear the memory by holding down the
I/O Enter key while the display counts down from three.
Run
For Data Logging setup, the run mode begins a session in memory and logs the
data. For Event Logging, each run/stop is stored as an event and a numeric
counter displays the number of saved events.
1. Begin a session by pressing the Run/Stop key from the view mode (or
measurement view). An asterisk in the lower right corner indicates the run
mode.
To toggle through the views, press the Up or Down Arrow.
Figure 1-14: Run mode indicator
2. End the session by pressing the Run/Stop key again. (The session will stop
recording when the asterisk is no longer displayed.)
NOTE: If the logging memory is full or if there are no sensors plugged into
the unit, attempting to enter the Run mode will result in an error message. If
the memory capacity is exceeded, the asterisk in the lower right corner of the
display will turn into an “F” and the memory remaining screen will show “0.0”.
Run indicator
Operating:
Print, reset, run