Filter
Top Products
52100 MAIN KIT includes:
• Canopy Frame.
• Left Upright Frame, (
plugged hole for wires in front leg.)
• Right Upright Frame, (plugged hole for wires in rear leg.)
• Pair of front V-Brace Bars with integrated clamp ends.
• V-Brace Console Castings: Front Casting & Top Casting (you will use one)
• Installation Hardware Kit
PARTS to be Purchased Separately from Your Dealer:
• Canopy Cover (your choice of color to best compliment your boat.)
• Standoffs (4 usually required, lengths to be determined for each boat.)
• Rod holders.
• Electronics box 54100.
• Navigation light.
TOOL List:
Your
Ttop can be installed using common hand tools. One person
can do it alone; however, it is much easier with two people. Allow 3-5 hours for
installation.
Required Tools: With these common tools you can install your Ttop.
1. Hand drill
2. sharp 1/4” drill bit
3. sharp 3/16” drill bit
4. ½” countersink bit
5. #3 Phillips screwdriver
6. tape measure
7. pencil
8. sharpie marker
9. 3/16” Allen wrench
10. 7/32” Allen wrench
11. 1/8” Allen wrench
12. 7/16” end wrench
13. 9/16” end wrench
Recommended Tools: We recommend you have the tools listed below,
especially the long drill bits and long screwdriver extension to make the install
easier.
1. Cordless variable speed drill
with torque control
2. 12” 1/4” drill bit
3. 12” 3/16” drill bit
4. #3 Phillips screwdriver tip
5. 12” drill extension for #3 tip
6. 7/16” deep socket ratchet
7. 9/16” ratcheting box end
wrench
8. Rubber mallet
9. Dremel tool (if windshield
notching is called for)
- 2 -