Filter
Top Products
26
2. Follow the instructions on the epoxy package and mix it thoroughly.
Do not mix it too fast, because it will cause bubbles to form in the ep-
oxy. Apply a small amount on the face of the transducer as shown
above, then spread a small amount onto the sanded area on the hull.
Place the transducer into the epoxy, twisting and turning it to force
any air bubbles out from under the transducer face. The face of the
transducer should be parallel with the hull, with a minimum amount
of epoxy between the hull and transducer. After the epoxy dries,
route the cable to the sonar unit.
Speed/Temperature Sensors
These units can accept additional temperature sensors which can be used
to monitor the temperature of surface water, a live well or some other lo-
cation. The SeaCharter 320DF can accept as many as three temperature
sensors, and the FishElite 320 can accept as many as two. These units can
also accept an optional speed sensor for showing speed and distance trav-
eled.
However, the FishElite 320 can only use one accessory at a time, so if you
would like to use a speed sensor and a second temperature sensor at the
same time, you will need a combination device. If you own a SeaCharter
320DF and would like to use a speed sensor and a second temperature
sensor at the same time, you will need an optional MY-4X cable.
NOTE:
These units are packed with a transducer containing a built-in temp
sensor. The SeaCharter 320DF package also includes a speed sensor.
If you have a FishElite 320 and want a speed sensor or additional
temp sensor, see the Accessory Ordering Information in the back of
this manual.
If a second temp sensor is used, it must be the model TS-2U for the
FishElite and the model TS-2X for the SeaCharter. These sensors have
a fixed electronic "address" which designate them as the second of two
temp sensors. Dual temperatures are only displayed on the Full Chart
page. The Large Digital page will only display the primary temperature
sensor. See the following wiring diagrams for temperature and speed
sensor combinations by unit.
NOTE:
SeaCharter 320DF units have been packed with one of two sen-
sor/cable configurations. One includes an MY-4X cable and SP-X sen-
sor and is shown on page 27. The other uses the SPY-X sensor and
does not include the MY-4X; it is shown on page 184.