Eagle Electronics 480 Fish Finder User Manual


 
34
Power connections for the FishElite 480 (shown left) and
SeaCharter 480DF (shown right) sonar/GPS units.
WARNING:
This product must be independently fused with the en-
closed 3-amp fuse (or equivalent), even if you connect to
a fused accessory or power buss.
If a malfunction happens inside the unit, extensive dam-
age can occur if the enclosed fuse is not used. As with all
electrical devices, this unit could be damaged to a point
that it is unrepairable and could even cause harm to the
user when not properly fused.
CAUTION:
Failure to use the enclosed 3-amp fuse will void your warranty! For
a replacement, use a type 3AG 3-amp fuse.
This unit has reverse polarity protection. No damage will occur if the
power wires are reversed. However, the unit will not work until the
wires are attached correctly.
An optional 8-foot, CA-4 external power cable with a cigarette lighter
adapter is available from Eagle.
NMEA/DGPS Cable Connections
(SeaCharter 480DF only)
NMEA is a standard communications format for marine electronic
equipment. For example, an autopilot can connect to the NMEA inter-
face on the SeaCharter 480DF and receive positioning information. The
SeaCharter 480DF can exchange information with any device that
transmits or receives NMEA 0183 data.
DGPS is an acronym for the Differential Global Positioning System.
DGPS supplements and boosts the accuracy of basic GPS. DGPS was
developed by the U.S. Coast Guard, which is responsible for the sys-
12 volt
battery
Black wire
Red wire with
3 amp fuse
To
FishElite 480
To
SeaCharter 480DF
12 volt
battery
Black wire
Optional power off switch
for saltwater installations