Filter
Top Products
33
Connections
Connect the signal and power cables, the
ground wire and optional equipment as shown
in Figure 5-12.
RP
HDG
NMEA
DJ-1
OPTION
MARINE RADAR
TYPE
SER.NO.
DATE
COMPASS SAFE DISTANCE
STD M STEER M
EQUPMENT CLASS
FURUNO ELECTRIC CO., LTD
10.2-31.2VDC
3 GND
1
2
Signal cable connector
Connect signal cable
from antenna here.
NMEA connector
Connect navaid
nere.
HDG connector
Connect heading
sensor nere.
Covered.
(not use)
Power cable connector
Connect power
cable here.
Ground terminal
Connect ground wire between
here and ship's ground.
OPTION connector
Connect navaid,
video sounder, etc.
here.
CAUTION
Tighten the boot-band
securely to ensure water
tightness.
See the procedure in
below.
Figure 5-12 Display unit, rear view
Signal cable connection
1. Connect the signal cable to DJ-1 on the rear
panel of the display unit.
Rubber cover
DJ Connector
Boot-band
Cable
Display unit
DJ-1
2. Cover the connector with the rubber cover.
The projection on the connector base is in-
serted into the groove on the rubber cover.
Display unit
Rubber cover
GraspGrasp
Groove
3. Put the boot-band as shown below, and
tighten it.
Display Unit
Boot-band