Filter
Top Products
6. CHART OVERVIEW
6-8
• Drop-down list button or slider bar: Rotate the knob to select an item or ad-
just the slider bar. Push the knob to confirm your selection or setting.
Note 1: You can use the ESC key to go back one step in the current operating
sequence.
Note 2: The InstantAccess knob can only adjust the slider bar on the
InstantAccess bar.
6.1.4 Sensor information box
Sensor information box displays the sensor data. When the user-selected sensor fails,
the system automatically selects another sensor. When this occurs, the color of the
sensor name changes from green to yellow. For details, see section 1.9.
6.1.5 Own ship functions box
The own ship functions box shows information about own ship, enables offset and TM
reset.
• [Offset] button: See section 16.8.1.
• [WGS 84] button: Convert position data between
datum; go to selected position on the current
chart. Click the button to display the dialog box
shown in the right figure. To convert a position
from one datum to another, select the datum
source at the [Source] pull-down list and enter po-
sition. Select the datum to convert to at the [Con-
verted] pull-down list then click the button. The
position on the chart selected is shown below the
[Converted] pull-down list. To go to a position,
click a [Go To] button.
TM/CU status
[Offset] button
ENC info
appears here.
[WGS84] button