Filter
Top Products
16
2 Rotate
3
1
Terminal Board TB1, TB3 Cross section
Insert
4
Special tool for
connecting wires,
fitted inside the
Distribution Box
Anticorrosive sheath
Armor
(Sectional view)
S =0.75 mm
=1.11 mm
2
Vinyl sheath
Conductor
Shield
Fabrication of cable TTYCYS-4
Power Supply Cable from Ship's Mains
If the ship's mains is AC, the power supply cable must be connected to TB5 in the Distribution
Box. In case of DC ship's mains, cable must be connected to TB6 in the Distribution Box. For
further information, refer to page 16.
Attaching EMI core
Attach EMI core (supplied) to the power cable to prevent noise.
13. Tape the power cable where the EMI core is to be attached, to hold the core in place.
14. Fasten the core close to the power cable connector.
EMI core
To distribution box
Display unit