Filter
Top Products
2. WIRING
2-10
3. Connect the remote controller cable to J2 on the control unit and use the support
plate to fix the cable.
4. Attach the cover.
5. At a distance of 1 cm from the control unit, attach the supplied EMI core (RFC-6)
to the remote controller cable.
How to connect No.2 control unit (option)
Two control units can be connected. On the No.2 control unit, remove the rear cover
and set the DIP switch as shown below.
Panhead screw
M4x12, 3 pcs.
Support plate
J2
Fix at copper tape.
Rear side of the control unit (cover removed)
S1
#1: ON
#2: OFF
#3: OFF
#4: OFF
4 3 2 1