Filter
Top Products
1. HOW TO INSTALL THE SYSTEM
1-9
1.3 Control Unit
The control unit can be installed in a console (flush mount) or on a desktop (with KB
fixture). Select a location considering the following points.
• Select a location where the controls can be easily operated.
• Locate the unit out of direct sunlight.
• Keep the unit away from water and water splash
• The length of the cable connected between the control unit and interface unit is 5 or
10 m. Select a location considering the length of the cable.
• Observe the compass safe distance (see the Safety Instructions) to prevent inter-
ference to a magnetic compass.
1.3.1 Control Unit FSV-8501
Desktop installation, with KB fixture
1. Fasten the KB fixture to the selected location with four self-tapping screws
(M5x20).
2. Connect a ground wire (1.25 sq, local supply) between the ground terminal at the
bottom of the unit and ship’s ground.
3. Set the unit on top of the KB fixture and fasten the unit with four binding screws
(M5x12) and wave washers.
4. Set cosmetic caps to fixing holes.
Flush mount
1. Prepare a cutout in the mounting location referring to outline drawing shown be-
low.
Set at rear
KB fixture
141±1
(5.64”)
130±0.5 (5.2”)
C18
(0.72”)
351±1
(14.0”)
340±0.5 (13.6”)
4 (0.16”) - Mounting hole