Furuno NAVpilot-720 Marine Instruments User Manual


 
1. INTRODUCTION
1-14
3. Rotate the Course control knob to select “1:” or “2:”, “3:” then push the knob. The
choices available for each division are as follows:
4. Rotate the Course control knob to select nav data desired then push the knob.
5. Set other patterns similarly.
6. Press the MENU key four times to close the menu.
Page 1
XTE
TTG
ETA
DATE
TIME
WIND TRUE*
1
WIND APPARENT*
1
VOLT
TRIP
Page 2
AIR TEMP
ATMOS PRESS
HUMIDITY
DEW POINT
Page 3
POS
COG
SOG
STW
TEMP
DPT
BRG
RNG
WPT
RUDDER
DEVIATION
NAVpilot-700 (When the RRU is installed): 1 of [1], [2]
NAVpilot-711, 720 (When the RRU is installed): 1 of [2], [3]
NAVpilot-700 (When the RRU is installed): 2 and 3 of [2], 1, 2 and 3 of [3]
NAVpilot-700 (For Fantum Feedback
TM
): 1 and 2 of [2], 1, 2 and 3 of [3]
NAVpilot-711, 720 (When the RRU is installed): 2 of [3], 1 and 2 of [4]
NAVpilot-711, 720 (For Fantum Feedback
TM
): 1 and 2 of [2]
NAVpilot-700: 1 of [4]
NAVpilot-711, 720 (When the RRU is installed): 1 of [5]
NAVpilot-711, 720 (For Fantum Feedback
TM
): 1 of [3]
COMPASS
*
2
RUDDER
*
2
HIGHWAY
WIND TRUE
*
1
WIND APPARENT
*
1
DEPTH
TEMP
ENGINE SPEED
Graphic display
*
1
Shown when [SHIP’S CHARACTERISTICS]=sailboat
*
2
Not shown in case of Fantum Feedback
TM
.
Note: For Fantum Feedback
TM
, the display as above is not showned.