Filter
Top Products
1. INSTALLATION
1-15
1.6 Initial Settings
Follow the procedures in this section to enter initial settings.
NOTICE
Improper menu settings may stop output of
data and display the message "RATE
ERROR." Be sure to enter correct data.
1.6.1 Confirming satellite status
Press the [SAT STATUS] key.
SAT TRACKING STATUS
TIMER 5 '52" OK
NO. GOOD STATUS
GPS1 8 8 D3D
GPS2 7 7 D3D
GPS3 8 8 D3D
Satellites
being
tracked
Satellites used for
measurement
"3D" shown when no
beacon receiver is used.
"W3D" shown when
receving WAAS.
"OK" displayed when
the "GOOD" column
shows that the number
of satellites acquired is
five or more.
Satellite tracking status display
When the system is turned on for the first time it is in the “cold-start” state, which
means there is no satellite data (almanac data) stored. In this condition it takes
about 12 minutes to find heading. When heading is found the display shows
“OK.” The timer at the top left corner of the screen shows time since power on. If
OK is not displayed within 30 minutes after turning on the power, the antenna
mounting location may not be suitable. Suspect that the number of satellites in
view is less than five due to signal blockage.