Fusionbrands MS-IP700i Marine Instruments User Manual


  Open as PDF
of 68
 
13
SETTING AND CLEARING THE ALARM
Use alarm mode to turn on the 700 Series at a pre-defined time.
When the alarm is activated, your 700 Series will play the last selected input
source at the volume level in use when the unit was turned off.
Menu key Encoder
To set the alarm:
1. Press the Menu key.
2. TurnandthenpresstheRotaryEncodertoselectSettings > Clock > Set alarm.
3. Do one or both of the following:
• TurntheRotaryEncodertochangethehoursetting.
• PresstheRotaryEncodertomovetotheminuteseld.Adjusttheminutes
settingasrequired.
• PresstheRotaryEncodertomovetotheAM/PMeld(ifenabled).Turn
encoder to select AM or PM.
4. Press the Menu key to save the time settings and exit (the time out feature does
notoperatehere).
5. HighlighttheAlarm enabledcheckboxandpresstheEncodertoenableit().
6. Press any key to exit
To clear the alarm:
1. Press the Menu key.
2. TurnandthenpresstheRotaryEncodertoselectSettings>Clock.
3. HighlighttheAlarmenabledcheckboxandpresstheRotaryEncodertodisable
it().
4. Press any key to exit
 previous next