Filter
Top Products
2
Select a dog.
3
Select Show Info > > Change Dog Type.
4
Select a dog type.
Changing the Dog ID
Before you can change the dog ID, the collar must be turned on
and within range of the handheld device.
If you are experiencing interference from other collars or
handheld devices in the area, you might need to change the ID
for the dog.
1
Select Dog List.
2
Select a dog.
3
Select Show Info.
4
Select > Change ID.
5
Select an available ID.
If another handheld device is tracking this dog, for best results,
remove the dog from the device, and use the track and train
codes (page 3) or share wirelessly over ANT+ (page 3) to add
the dog again.
Setting Dog Alerts
You can adjust how the handheld device alerts you to certain
actions of the dog.
1
Select Setup > Dogs > Dog Alerts.
2
Select an alert.
3
Select the handheld device action for the specific alert.
4
Repeat steps 2 and 3 as needed.
Removing a Dog
1
Select Dog List.
2
Select a dog.
3
Select Remove.
Attaching the Collar on Your Dog
CAUTION
To prevent irritation from the contact points, remove the collar
for at least 8 hours out of every 24-hour period.
NOTICE
Remove the charging clip before putting the collar on the dog. If
you do not remove the clip, it may become detached from the
collar and become lost.
Before you put the collar on the dog, pair the handheld device
and collar (page 3), and acquire satellite signals (page 2).
1
Select an option:
• If you are training your dog with the collar, select and
install the appropriate contact points (page 6).
• If you are not training your dog with the collar, install the
cap over the contact point locations (page 6).
2
Place the collar in the middle of the dog's neck, directly
behind the dog's ears.
3
Position the collar with the VHF whip antenna pointing up,
the GPS antenna facing up, and the LEDs facing forward.
When using the contact points, they can be positioned
anywhere along the dog's neck. The best location for the
contact points is in the front of the neck.
4
Tighten the strap so that it is snug around the dog's neck.
5
If the strap is too long, cut off the excess, leaving at least 3
inches to spare.
Communication with the Collar
If the collar and handheld device came in the same packaging,
they were paired at the factory. If you are using a collar or
handheld device that you purchased separately, add the collar
to the handheld device to establish a communication link
between the collar and handheld device (page 3).
The collar and handheld device must be within range to
communicate with each other. The MURS/VHF radio
communication range is up to 9 miles.
The collar and handheld device use radio signals to
communicate. Objects in the path of radio signals degrade the
quality of the signals. Keeping an unobstructed line of sight
between the collar and handheld device produces the best
communication signal. Obstructed radio waves result in a poor
signal. To achieve the best line-of-sight conditions, move to the
highest elevation point in your area (for example, on the top of a
hill).
Best
Good
Poor
Dog Tracking
The Alpha system allows you to track your dog, up to 9 miles
away, using the dog tracking compass or map. The map
displays your location and your dog's location and tracks. The
pointer acts like a compass, pointing in the direction of the dog's
current location.
One Alpha handheld device can track up to 20 devices (TT dog
collar devices and Alpha handheld devices).
NOTE: Both the collar and the handheld device must have
acquired satellites before you can track the dog on the handheld
device.
4 Dog Tracking