Filter
Top Products
1
Installation
Installing the Fishfi nder 250/250C
The Fishfi nder 250/250C must be properly installed according to the following instructions to get the
best possible performance. To complete the installation, you’ll need the appropriate fasteners and tools.
Verify that all cables can reach the unit mounting location and also take time to read through these instruc-
tions prior to installation. Be sure to always wear safety goggles and a dust mask when drilling, cutting or
sanding. When in doubt, seek professional assistance.
Selecting a Proper Location
Choose a location that provides optimal viewing while operating the vessel and allows easy access to
the unit’s keypad. Select a mounting surface strong enough to support the weight of the unit and protect
it from excessive vibration and shock. DO NOT mount the bracket in a location where the unit is exposed
to extreme temperature conditions. When installing the mounting bracket, be sure to allow room for the
connection/routing of the power and transducer cables.
Swivel Mounting the Fishfi nder 250/250C Unit
The Fishfi nder 250/250C’s compact, waterproof case is suitable for mounting in exposed locations or
at the nav station. The unit comes with a swivel-mount bracket that can be used for console or overhead
mounting. When choosing a location for the display unit, make sure you consider the following conditions:
• There should be at least a 3” (8 cm) clearance behind the case to allow connection of the transducer
and power/data cables.
• The mounting surface should be sturdy enough to support the unit and protect it from excessive
vibration and shock.
NOTE
:
The temperature range for the Fishfi nder 250/250C is 5°F to 130°F (-15°C to 55°C).
Extended exposure to temperatures exceeding this range (in storage or operating condi-
tions) may cause failure of the LCD screen. This type of failure and related consequences are
NOT covered by the manufacturer’s limited warranty.
,
Unit Installation
250C Manual.indd 1 1/27/2004, 3:54:51 PM