Garmin 400C Fish Finder User Manual


  Open as PDF
of 40
 
4 Fishnder 400C Owner’s Manual
customIzIng the FIshFInder 400c
To adjust the Keel Offset:
1. HighlightKeel Offset,andpressSELECT.
2. UsetheROCKERtosetthevalueofthekeeloffset.
3. PressSELECTtoacceptthenumber.
NOTE: Press MENU to cancel your changes and return to the
Transducer menu.
Calibrate Water Speed—to use a speed sensing transducer, use
this menu to calibrate the speed sensor. If you are not using a speed
sensing transducer, this menu does not appear.
To calibrate the speed sensor:
1. HighlightCalibrate Water Speed,andpressSELECT.
2. Bringtheboattocruisingspeed.Noteyourtopspeed,and
thenstoptheboat.
3. HighlightOK,andpressSELECT.
NOTE: If the boat is not moving fast enough or the speed sensor
is not registering a speed, a “Speed Too Low” message appears.
Highlight OK, press SELECT, and safely increase boat speed. If
you get the message again, stop the boat and make sure the speed
sensor wheel is not stuck. If the wheel turns freely, check the
cable connections. If you continue to get the message, contact
Garmin Product Support.
Customizing Units of Measure
To change the units of measure, on the Congure screen, highlight
Units, and press SELECT.
Depth—select Feet (ft), Meters (m), or Fathoms (fa).
Water Temp —select Fahrenheit (°F) or Celsius (°C) (with a
compatible transducer).
Water Speed—select Miles/Hour (mh), Kilometers/Hour (kh), or Knots
(kt) (with a compatible transducer).
Distance—
select Statute (mi), Metric (km), or Nautical (nm) (with a
compatible transducer).
 previous next