Filter
Top Products
When the button is pressed the LED next to 9 will come on, the system will drop
out of autopilot and put you in a starboard remote turn. To return to autopilot
press and release the right straight arrow button.
When the button is pressed the LED next to 6 will come on, the system will drop
out of autopilot and put you in a port remote turn. To return to autopilot press and
release the left straight arrow button.
Throttle up button, press and hold for large RPM changes or momentarily press for
small RPM changes. LED in upper left will illuminate every time button is pressed.
Throttle down button, press and hold for large RPM change or momentarily press for
small RPM changes. LED in lower left will illuminate every time button is pressed
The next two basic operations are factory defaults and may be changed by user at any
time using the feature operation changes.
Pushing and releasing the Idle/Resume button will cause the motor to go to idle.
Press and release the button again and the motor will return to its previous RPM
setting. To use this button as a MOB (man overboard) or Zig-Zags see page 4.
3
How to adjust throttle:
Bent Arrow Buttons are programmed from the factory for Remote Steering. No Heading hold operations
are available while using this feature. If you wish to program the bent arrows for Step Turns or Circles, see
page 4.