Filter
Top Products
Compass Calibration
Example of button sequence below;
Autopilot in Standby
3) Press and hold the button, now press and release the Deckmount (on/off) button quickly,
the Up Arrow LED will now come on now release button
2) Now press button the 4 LED will now be on. Now press button the 7 LED will now be
on and display code “47”
4) Steer your boat (with the tiller or main engine) on a steady heading, in forward at a low RPM.
5) When Up Arrow LED starts blinking steer your boat in a medium to slow starboard turn (with
tiller or main engine) and start your rst 360 degree circle.
6) When approximately 3 circles are complete and LED’s will extinguish and the Up and
Down Arrow LED’s will light solid for about 5 seconds the system will then shut down
completely, the compass calibration is complete
If Up and Down Arrows both continue to blink and does not power down after 5 seconds, the compass
Calibration failed. Shut down system completely and re calibrate compass.
1) Put the autopilot in Setup mode by momentarily pressing the setup LED should be lit on the
Hand Held
9