Garmin PN 906-2001-00 Marine Instruments User Manual


 
Setup Action Code # Range of Settings or Responses Factory
Default
Setting
Tach on/off 34 2 Settings: on or off on
Show motor RPM 36 Hold Down Select Load Button: 1000’s blink on up arrow
100’s blink on down arrow
Standby Safety Monitor 349 2 settings on, off defaults to on every power up on
Throttle Delay 25 1 lowest speed, 10 highest speed 5
Throttle Speed 24 1 lowest speed, 10 highest speed 5
Reversed Hoses 259 2 settings normal up arrow lit, reverse down arrow lit norm
Calibrate Compass 47 Hold down select load button, press and release
Deckmount button to start Calibration process
Load Factory Compass 49 Hold down select load button, press and release
Deckmount button to reload Factory Compass Calibration
Load Factory Pilot 59 Hold down select load button, press and release
Deckmount button to reload Factory Pilot Settings
Nav Gain 15 1 lowest gain, 73 highest gain 42
Nav Trim Gain 16 1 lowest gain, 73 highest gain 49
Use Synthetic XTE 37 2 settings on, off off
Change Sigh of XTE 18 2 settings on, off off
Use Magnetic North 39 2 settings on, off on
Enable Checksums 347 2 settings on, off on
Set North 48 Hold down Select load, press & release DM button to set
Seastate Filtering 1 1 least responsive steering, 4 most responsive steering 4
Rudder Gain 2 1 lowest gain, 60 highest gain 22
Counter Rudder Gain 3 1 lowest gain, 60 highest gain 37
Speed Schedule 35 4 settings 1 aggressive, 2 moderate, 3 mild, 4 weak 4
Table of Setup Codes
7
Degrees per Step 6 10 Choices 1, 2, 3, 4, 5, 10, 15, 30, 45 or 90 Degrees 15
Circle Time 7 10 Choices 1, 2, 3, 4, 5, 10, 15, 30, 45 or 90 Minutes 5
Zig-Zag Amplitude 8 10 Choices 5 to 50 Degrees by 5’s 30
Zig-Zag Period 9 20 Choices 1/2 to 10Minutes by 1/2’s 3
MOB Overshoot 28 1 most overshoot command, 40 most undershoot com-
mand
20
Clover Leaf Length 29 500 ft. to 6000 ft. by 100 ft. increments 1000
Search Spacing 249 50 ft. to 1000 ft. by 50 ft. increments 50
Special Steering Functions Setup Codes